![]() ![]() L frame guns use K frame grips, so they should be taken care of as well. The prototypers found that it also fit round butt K frames, and both square and round butt N frames. You can check this thread for the discussion that went on during initial development of these adapters, and for photos of the fit on various J frame guns: įITTING FOR S&W K, L and N FRAMES: The larger S&W adapter was made for square butt K frames. When the grips are tightened down on all of the clips, this will insure that the adapter is locked solidly in place against the metal and wood, where it’s supposed to be.įITTING FOR S&W J FRAMES: There was an early report of poor fitting on an M&P 340 Scandium frame model, but I have not had subsequent reports of problems. (Sorry about that.) For the best fit, as you tighten the grip screw, be sure to hold the adapter tightly against the wood grips and against the curve of the frame above and behind the trigger guard. This can happen because of imperfect alignment between the two clips. The 2-clip design means that, initially, the adapter may not seem to fit as straight on the grip frame as the older single clip models. ![]() The adapters for S&W models work equally well on round and square butt frames. They do NOT work with grips that fill in or cover any of the metal behind the trigger guard or on the front of the grip frame. FITTING IN GENERAL: Remember that these devices are designed to be used with traditional service or Magna grip panels which leave the front strap exposed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |